Inet6 fe80::1%lo0 prefixlen 64 scopeid 0x7Īlso so we are sure. You do show your lo up and on 127.0.0.1? with an ifconfig lo0: flags=8049 metric 4 Pass out on lo0 inet6 all flags S/SA keep state label "pass IPv6 loopback" Heres a 1 minute wait example: ping -t -w 60000. Pass in on lo0 inet6 all flags S/SA keep state label "pass IPv6 loopback" This is the windows command I use to ping a specific IP at a specified interval (10 seconds in this example): ping -t -w 10000.Pass out on lo0 inet all flags S/SA keep state label "pass IPv4 loopback" I created a LoopBack 4 App to implement CRUD operations on User data model following the LoopBack 4 tutorial and the app works fine in VSCode and with Dockerization (Linux Container mode). (1)ping the loopback IP address: Switchping -f -s 7000 1.1.1.1 PING 1.1.1.1: 7000 data bytes, press CTRLC to break Reply from 1.1.1. Pass in on lo0 inet all flags S/SA keep state label "pass IPv4 loopback" So here example you see me doing that above test while doing a packet capture on localhost for my port 8443įor grins check your loopback rules pfctl -sr | grep loopback So you can actually see the connection attempt, and the source IP, etc. * SSL certificate problem: self signed certificate in certificate chainĬurl: (60) SSL certificate problem: self signed certificate in certificate chainĪlso sniff on the localhost while you try and do your test. * TLSv1.2 (OUT), TLS alert, unknown CA (560): There is no way to define a timeout value for any of the tests. * TLSv1.2 (IN), TLS handshake, Certificate (11): Hi, The Test-NetConnection PowerShell cmdlet uses Write-Progress for status messages and Write-Warning to report failure states (Ping or TCP connect failed) to the console. To confirm this, try running arp -a on your machine, and youll see a list of all the IP addresses that could be found on your LAN. * TLSv1.2 (IN), TLS handshake, Server hello (2): It just means that the arp failed, i.e., the IP address couldnt be located on the LAN. * TLSv1.2 (OUT), TLS handshake, Client hello (1): * TLSv1.2 (OUT), TLS header, Certificate Status (22): * CAfile: /usr/local/share/certs/ca-root-nss.crt * Cipher selection: successfully set certificate verify locations: Connection attempts from this server to other servers using these clients also work. Connection attempts into this server from outside, using the same clients, work. My ultimate goal is to ping lo0:192.20.11.1 on router 'Good'. I advertise the respective networks Lo0 and Lo1 via OSPF, so I am not sure if I can understand whats going on. Lets see the output of your curl with the -v so we can see exactly what is going on. the /etc/hosts file contains a line: 127.0.0.1 localhost so localhost should be a valid hostname, but any attempt to connect to a port on localhost fails, including ping. From WG4R3 I cant ping Lo0 and Lo1 on WG4R2 and vice and versa. on mine for example ps -ax | grep 82772Ĩ2772 - Is 0:00.00 nginx: master process /usr/local/sbin/nginx -c /var/etc/nf (nginx)Īgain there is no firewall rule that would prevent access to itself. Those are the pids of the processes, 2 workers and the main one.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |